Purpose-built for unattended storage lot use, the ADCO 01-2700 wraps your travel trailer in a breathable, UV-treated four-layer polypropylene shell that blocks sun, rain, and road grime while letting trapped moisture escape. Covers this size range with a reinforced corner system, a positive CAM buckle cinching system, and built-in vents -- so the cover stays put and your trailer comes out of storage looking like it went in.
Leaving a travel trailer uncovered in a storage lot for weeks or months accelerates UV cracking on sidewalls and caulk, promotes black streak formation off the roof, and invites mold growth under a non-breathable cover. The ADCO 01-2700 addresses all three problems with a construction and fastening system designed specifically for the storage lot environment -- not just the occasional weekend at home.
The four-layer polypropylene fabric is water-resistant on the outside, breathable throughout, and UV-stabilized so the cover itself doesn't degrade and transfer damage to your rig. Reinforcements at all eight corners -- top and bottom -- protect the high-wear points where most covers fail first.
Breathable and water-resistant sides block rain and UV while allowing interior moisture to escape, preventing mold and mildew buildup during long storage periods.
Front, rear, and bottom CAM buckles lock the Slip-Seam strapping system tight at all four bottom corners, removing slack and preventing the billowing that causes cover wear and wind ejection.
Extra reinforcement material at every corner -- four top, four bottom -- significantly reduces snag and tear risk where the cover contacts ladder rungs, bumper corners, and tie-down hardware.
Integrated vents allow warm air to escape from under the cover, equalizing pressure that would otherwise cause ballooning and reducing condensation on interior surfaces.
By keeping the roof surface clean and shielded from UV, the ADCO storage cover actively reduces black streak formation -- the dark stains that run down sidewalls from dirty roof seams after rain. Fewer streaks means less washing, less waxing, and fewer roof sealant touch-ups between uses.
Unlike covers that rely on a single belly-band or loose tie-down loops, the Slip-Seam system routes straps along sewn channels on the underside of the cover. When the CAM buckles are cinched, the fabric draws uniformly tight against the trailer's profile at all four corners simultaneously. This matters on a storage lot where nobody is checking the cover daily -- the system is designed to stay secure through wind, rain, and temperature cycles without adjustment.
The weighted buckle toss-under tool included in the kit simplifies routing straps under the trailer during solo installation without crawling on the ground.
Choosing a cover that is too short will leave the nose or tail exposed. Choosing one that is too long allows excessive fabric to pool at the bottom, creating wind-catch points and accelerating wear at the corners.