Clamps to any cockpit railing and positions a Kuuma grill outboard of the rail to protect fiberglass from spills. Fits 7/8"–1-1/4" O.D. round horizontal or 1-1/4" square railings. Rust-resistant anodized aluminum. 9" L x 2" W x 2-1/2" H. All hardware included. Compatible with all Kuuma grills.
The Camco Kuuma 58182 is a cockpit rail grill mount that clamps directly to a boat's horizontal railing — no rod holders needed. It positions the grill inboard or outboard of the rail (hence the "inboard/outboard" designation), with the outboard position being the typical choice to keep grill smoke, spills, and grease away from the boat's cockpit and fiberglass surfaces.
The mounting bracket clamps to 7/8"–1-1/4" round horizontal railings or 1-1/4" square railings, making it compatible with the vast majority of production boat cockpit rails. Construction is rust-resistant anodized aluminum for long-term marine use, and all installation hardware is included. The compact 9" x 2" x 2-1/2" footprint keeps it unobtrusive on the rail when not in use.
• 1x Camco Kuuma 58182 Inboard/Outboard Rail Mount • All installation hardware
The 58182 can position the grill on either side of the railing: Outboard (recommended): Grill hangs outside the railing over the water — keeps smoke, grease, and spills away from the cockpit and fiberglass. Most common configuration. Inboard: Grill mounts inside the rail — keeps it closer to the cooking area but risks drips on the cockpit surface. May be preferred on certain boat layouts where outboard positioning is impractical.
• 58180 — 60° rod holder mount (fixed angle, height adj. to 5") • 58182 — Rail clamp, 7/8"–1-1/4" rail O.D. (this item) • 58183 — Universal single-axis adjustable rail mount • 58184 — Pedestal mount with quick-release base (dock/patio) • 58196 — Pivoting rod holder mount, 1-5/8" flush mount, full ball-joint swivel Choose 58182 when you have standard round or square cockpit railings and want a simple clamp-on solution. Choose 58183 for more complex rail geometries or angles.
The 58182 is designed for horizontal railings. It will not clamp properly to vertical stanchions or angled rails outside the 7/8"–1-1/4" diameter range. Measure your railing O.D. before ordering to confirm fit.