When your Schwintek-equipped RV bed tilt system stops responding, a failed controller module is often the culprit. The Lippert 260793 Hall Effect controller is the genuine OEM replacement designed to bring your bed tilt system back online -- no jury-rigged workarounds, no guesswork. Confirm your original part number before ordering to ensure a direct match.
The Lippert 260793 is a Hall Effect-based control module built specifically for Schwintek bed tilt slide-out systems found in a wide range of towable and motorized RVs. Hall Effect technology uses magnetic field sensing rather than mechanical contacts, which means greater reliability and longer service life compared to older brushed or contact-based controllers.
This is a controller module replacement only -- it does not include motors, wiring harnesses, remote handsets, or mounting hardware. It is intended for owners replacing a confirmed failed or damaged controller in an existing, otherwise functional Schwintek bed tilt installation.
Magnetic position sensing eliminates mechanical wear points, providing reliable motor feedback and precise tilt control.
Factory-spec replacement module -- not an aftermarket clone. Matches original calibration and communication protocols for Schwintek systems.
Designed to swap into the existing controller mounting location with the same connector footprint as the original 260793 module.
Brings back tilt-up, tilt-down, and position-hold operation lost when the original controller fails or is damaged.
The bed tilt controller is the brain of the Schwintek bed tilt mechanism. It reads position signals from the Hall Effect sensors in the motor assembly, interprets commands from the wall switch or remote, and drives the motor in the correct direction and duration. When the controller fails, the bed may not move, may move only in one direction, or may throw a fault code on compatible systems. Replacing this module resolves controller-side faults without disturbing the motor or actuator.
Lippert part number: 260793Vendor/distributor part number: 15-9365UPC: 848150047465These numbers can be used to confirm fitment with your RV manufacturer's parts list or a Lippert dealer lookup.
Not all Schwintek bed tilt installations use the same controller. Lippert has released multiple controller revisions across model years. Verify that 260793 matches the original part number on your existing controller before purchasing. Your RV owner's manual, the Lippert parts lookup at lci1.com, or a Lippert dealer can confirm compatibility by VIN or model year.