The Lippert 733926 gives you fast, reliable height adjustment at the tongue of your A-frame trailer. With 14 inches of travel, a drill-compatible drive nut, and a textured topwind handle, this jack is built for real-world use on cargo, utility, and travel trailers. Steel construction with black powder coat keeps it standing up to the elements trip after trip.
Hitching and unhitching is one of those tasks that should be quick and painless. The Lippert Quick Drop Tongue Jack is engineered to do exactly that -- raise and lower your trailer tongue smoothly, hold 2,000 lbs without flex, and get out of the way when you're done. The topwind design keeps the handle clear of the frame, and the quick-drop mechanism speeds up the initial descent so you're not cranking from full height every time.
The drive nut is built into the mechanism so you can chuck a standard 3/4-inch socket into your power drill and run the jack up or down in seconds. Manual cranking is always available as a backup. Both approaches use the same textured-grip handle that folds flat for travel.
Rated for 2,000 lbs of tongue weight -- suitable for most cargo, utility, and travel trailer applications on standard A-frame couplers.
Built-in drive nut accepts a 3/4-inch socket so you can use a power drill for fast raising and lowering. Socket not included.
Full 14 inches of vertical travel handles a wide range of hitch-ball-to-ground height combinations without needing extension tubes.
Locking-pin footpad removes quickly for travel or when working on hard surfaces where a smaller footprint is preferred.
The topwind handle sits above the mounting bracket, so your hand never has to reach under the frame or fight with the trailer tongue. The textured grip gives you control even with gloves on. When you reach your desired height, the handle folds into its stored position and stays there -- no zip-tie needed.
For even faster operation, the 3/4-inch hex drive nut lets you run the jack with a cordless drill. This is especially useful if you are hitching solo, working on uneven ground, or just want to save your shoulder on a long day of moving trailers around a property or job site.
The 733926 is built from steel with a black powder coat finish. Powder coat provides a barrier against rust and abrasion that holds up better than standard paint on a part that regularly contacts wet ground, mud, and road spray. The inner and outer tubes are sized for smooth, rattle-free operation -- 2-inch inner tube inside a 2-1/4-inch outer tube.
The 733926 mounts to the A-frame tongue with a weld-on or bolt-on bracket (bracket style determined by your trailer's existing mount). Key clearance measurements:
Confirm these measurements against your trailer's tongue clearance and any fairleads, chains, or safety cables that pass near the jack location before installing.