Home > LP Gas > LP Hoses >

Camco 59153 Pigtail Propane Connector Hose 24 Inch ACME x 1/4" Male Inverted Flare CSA Approved

Camco 59153 24-inch propane pigtail connector hose with ACME fitting and 1/4-inch male inverted flare for RV propane regulators and 4-port tees
Camco Pigtail Propane Connector Hose - 24"
 
Alternative Views:


List Price: $34.19
: $26.49
You save $7.70!
Part Number: 59153
Manufacturer: Camco

Quantity in Stock :39

Availability: In Stock
Qty:

 
Camco CSA Approved 200,000 BTU/hr Camco 59153 Propane Pigtail Connector Hose -- 24"

A reliable, code-approved link between your 20 lb or 30 lb propane cylinder and your RV regulator or 4-port brass tee. Built with thermal shutoff and excess-flow protection, this hose is a safety-first upgrade over bare fittings and older rubber lines.

Hook Up Your Tank the Right Way

The Camco 59153 propane pigtail hose gives you a flexible, durable connection from a standard refillable cylinder to your RV propane system. The 24-inch length provides enough slack to open and close the tank valve without straining the fitting, and it works equally well as a primary supply line or as an auxiliary connection on a 4-port brass tee setup.

Both end fittings are pre-assembled and tested. The POL/ACME end threads onto a standard DOT cylinder valve, while the 1/4-inch male inverted flare connects directly to most RV regulators and 4-port tee ports. No adapters needed for typical single- or dual-tank RV configurations.

Thermal Shutoff

Built-in thermal protection automatically restricts flow if the hose is exposed to fire -- reducing fire spread risk during an emergency.

Excess Flow Protection

Integral excess-flow valve cuts gas flow if the downstream line ruptures or is severed, helping prevent uncontrolled gas release.

High BTU Rating

Rated at 200,000 BTU per hour -- more than enough capacity for RV furnaces, stoves, water heaters, and refrigerators running simultaneously.

CSA Certified

CSA approval confirms the hose meets Canadian and U.S. safety standards for LP gas supply lines -- required by many campgrounds and RV parks.

Compatible Tank and System Configurations

This hose is designed for use with 20 lb and 30 lb refillable DOT propane cylinders -- the most common sizes used on travel trailers, fifth wheels, and toy haulers. It is not intended for 1 lb disposable cylinders or ASME horizontal tanks.

  • Connects directly to a single-stage or two-stage RV propane regulator
  • Threads onto any standard 4-port brass propane tee (sold separately) as a primary or auxiliary supply
  • Works in dual-tank manifold setups -- use two hoses, one per cylinder
  • Compatible with Camco 4-port brass tee fittings and most OEM RV regulator inlet ports
Auxiliary Supply Option: Connect this hose to an installed 4-port tee to add a second or third cylinder as an auxiliary propane supply -- a popular upgrade for extended off-grid or boondocking trips where tank swaps are inconvenient.

Installation Notes

Thread the ACME fitting hand-tight onto the cylinder valve, then snug with a wrench -- do not overtighten. Connect the 1/4-inch male inverted flare end to your regulator inlet or tee port and tighten with a flare-nut wrench. Apply soapy water to all connections after assembly and check for bubbles before lighting any appliances.

Heads Up: Inverted flare fittings must seat metal-to-metal -- do not use pipe thread tape (Teflon) on flare connections. Use only on the threads if converting to a different fitting style.

Replacement and Inspection

Propane hoses should be inspected before each season and replaced if you notice cracking, brittleness, kinking, or any odor of gas near connections. The Camco 59153 carries a limited 90-day warranty against defects in materials and workmanship.

Maintenance Tip: Store the hose coiled loosely when the RV is not in use. Avoid letting the hose rest against sharp chassis edges or hot surfaces such as converter housings or exhaust components.

Hose Specifications

ManufacturerCamco
Manufacturer Part #59153
SKU66-8917
UPC014717591539
Hose Length24 inches
Weight0.43 lbs
BTU Rating200,000 BTU/hr
CertificationCSA Approved
WarrantyLimited 90-day

Fitting Specifications

Cylinder End FittingACME (POL-style) -- fits standard DOT cylinder valve
Regulator/Tee End Fitting1/4" Male Inverted Flare
Connection TypeMetal-to-metal flare seal (no thread tape on flare end)

Safety Features

Thermal ProtectionYes -- automatic flow restriction on heat/fire exposure
Excess Flow ProtectionYes -- shuts down flow on downstream line break
CertificationCSA (Canadian Standards Association) -- meets U.S. and Canadian LP gas code

Compatible Tank Sizes

20 lb DOT CylinderYes
30 lb DOT CylinderYes
1 lb Disposable CylinderNo
ASME Horizontal TankNo

In the Box

Quantity1 hose assembly
Regulators IncludedNo -- sold separately
4-Port Tee IncludedNo -- sold separately
Important Information
  • For use with 20 lb and 30 lb refillable DOT propane cylinders only -- not compatible with 1 lb disposable canisters or ASME horizontal tanks.
  • Do not use Teflon tape on inverted flare connections -- flare fittings seal metal-to-metal and tape will interfere with the seal.
  • Always perform a leak check with soapy water after installation before operating any propane appliances.
  • Inspect the hose for cracking, kinking, or brittleness before each camping season. Replace immediately if damage is found.
  • Keep the hose away from heat sources, sharp edges, and moving chassis components during installation and use.
  • Propane regulators and 4-port tees are sold separately and are not included with this hose.
  • Limited 90-day warranty against manufacturing defects.


Browse for more RV Accessories in the same category as this item:

LP Gas > LP Hoses
LP Gas


$35.95
$329.95
$146.99
$10.72