Home > LP Gas > LP Hoses >

MB Sturgis 100429-48 Low-Pressure LP Propane Hose 3/8" ID x 48" -- 1/2" Female Flare Swivel x 3/8" Male Pipe Thread
MB Sturgis 100429-48 low-pressure LP propane hose, 3/8" ID x 48", 1/2" female flare swivel x 3/8" male pipe thread fitting ends
MB Sturgis 3/8" ID Low-Pressure LP Hose - 48"
  
List Price: $20.32
: $14.49
You save $5.83!
Part Number: 100429-48
Manufacturer: MB Sturgis

Quantity in Stock :21

Availability: In Stock
Qty:

 
MB Sturgis Low-Pressure Propane 350 PSI Rated MB Sturgis 100429-48 -- 3/8" ID Low-Pressure LP Hose, 48"

A reliable, purpose-built propane supply hose for connecting the pressure regulator to the permanent gas piping system in motor coaches, travel trailers, and fifth wheels. With 1/2" female flare swivel and 3/8" male pipe thread ends, this hose drops into place on standard RV LP installations without adapters.

Regulator-to-Piping Connection You Can Count On

MB Sturgis has built propane components for the RV industry for decades. The 100429-48 hose is designed specifically for low-pressure downstream service -- the segment of the LP system between the two-stage or single-stage regulator and the coach's internal copper or steel gas piping. At 48 inches, it provides enough working length to clear chassis obstructions, allow for slight movement between the hose reel or tank compartment and the entry point of the piping system, and still route cleanly without excessive slack.

The 1/2" female flare swivel fitting mates to the standard 1/2" male flare outlet found on most RV LP regulators, while the 3/8" male pipe thread end threads directly into a 3/8" female pipe fitting on the coach's permanent gas line. The swivel design on the regulator end prevents the hose from twisting during installation and allows for easy alignment without wrench-fighting.

350 PSI Working Pressure

Rated for 350 PSI maximum -- well above the 11" W.C. (roughly 0.4 PSI) delivered on the low-pressure side of an RV regulator, providing a substantial safety margin.

Wide Temperature Range

Rated from -40 F to 140 F, covering everything from cold-weather winter camping to summer desert use without hose degradation.

Swivel Fitting End

The 1/2" female flare end swivels freely, making regulator connections fast and preventing hose torque that can stress fittings over time.

Direct Fit -- No Adapters

Standard 1/2" female flare x 3/8" MPT end configuration matches the most common RV regulator outlet and gas piping entry sizes out of the box.

Where This Hose Is Used

This is a low-pressure downstream hose, meaning it is installed on the outlet side of the LP regulator, not between the tank and the regulator. Common installation points include:

  • Motorhome and motor coach LP compartments -- regulator outlet to chassis piping entry
  • Travel trailer and fifth wheel hitch areas -- regulator to underbelly gas line
  • Replacement of cracked, kinked, or age-hardened OEM low-pressure hose during LP system service
  • New installation or re-routing where additional hose length is needed versus a short factory connection
Swivel Fitting Simplifies Install: The rotating 1/2" female flare end lets you hand-tighten onto the regulator outlet and orient the hose run before final torque -- no need to spin the entire hose body.

Thread and Fitting Identification

Confirming the right hose before you order saves a trip back to the parts shelf. Here is how to identify the fittings on your existing connection:

  • Regulator outlet end: Look for a flared brass fitting with a hex nut that threads onto a male flare stub. If it is 1/2" nominal flare (7/8"-14 UNF thread), this hose fits.
  • Gas piping entry end: If the permanent piping has a 3/8" female pipe thread (3/8" NPT) port, the male pipe thread end of this hose threads directly in.
  • If your installation uses 3/8" female flare or 1/4" pipe thread, different end configurations or adapters are required -- this hose is specifically 1/2" female flare swivel x 3/8" MPT.
Low-Pressure Service Only: This hose is rated and designed for the low-pressure (second-stage regulated) side of an RV LP system. Do not use it for high-pressure tank-to-regulator service. For high-pressure pigtail hoses, see the appropriate MB Sturgis high-pressure hose series.

Installation and Leak-Check Tips

  • Use an approved pipe thread sealant (yellow gas-rated PTFE tape or liquid sealant) on the 3/8" male pipe thread end only -- never apply sealant to flare fittings.
  • Tighten the 1/2" female flare swivel nut to snug plus approximately 1/4 turn with a wrench. Do not overtighten flare fittings.
  • After installation, perform a soap-bubble or electronic leak check at both ends before lighting any appliances.
  • Route the hose clear of exhaust components, sharp edges, and moving chassis parts. Use a hose clamp or tie wrap to secure routing if needed.
  • Inspect annually for cracking, stiffness, abrasion, or fitting corrosion and replace if any damage is found.
Maintenance Reminder: LP hoses should be inspected at least once per season. UV exposure, ozone, and freeze-thaw cycling can degrade rubber over time even if the hose is not leaking yet. When in doubt, replace it -- a low-pressure LP hose is inexpensive insurance.

Product Specifications

ManufacturerMB Sturgis
Part Number100429-48
Vendor Part Number06-1395
SKU69-6617
UPC764560529158

Hose Dimensions

Hose Length48 inches
Hose ID3/8 inch
Hose Weight1.25 lbs

Pressure and Temperature Ratings

Maximum Working Pressure350 PSI
Minimum Temperature-40 F
Maximum Temperature140 F
Service TypeLow-pressure LP (downstream of regulator)

Fitting Configuration

Regulator End1/2" Female Flare Swivel
Gas Piping End3/8" Male Pipe Thread (MPT / NPT)
Swivel FeatureYes -- regulator end rotates for easy alignment

What Is Included

Quantity1 hose, sold individually
Fittings IncludedPre-installed on both ends
Adapters IncludedNone
WarrantyLimited 1-year manufacturer warranty

Compatibility

ApplicationMotor coaches, travel trailers, fifth wheels
System PositionRegulator outlet to permanent gas piping (low-pressure side)
Regulator Outlet FitStandard 1/2" male flare regulator outlets
Piping Entry Fit3/8" female pipe thread (NPT) gas line ports
Important Information
  • This hose is rated for low-pressure LP service only (downstream of the regulator). Do not use on the high-pressure side between the tank and regulator.
  • Maximum working pressure is 350 PSI -- do not exceed this rating or use with unregulated tank pressure.
  • Do not apply thread sealant or PTFE tape to the flare swivel fitting end. Use gas-rated sealant on the 3/8" male pipe thread end only.
  • Always perform a leak check after installation before operating any LP appliances.
  • Inspect the hose regularly. Cracking, stiffness, discoloration, or fitting corrosion are signs the hose should be replaced immediately.
  • This hose is sold individually and does not include adapters, regulators, or pipe fittings.
  • LP system work must comply with applicable NFPA 58, RVIA, and local codes. When in doubt, have a certified LP technician inspect the installation.


Browse for more RV Accessories in the same category as this item:

LP Gas > LP Hoses
LP Gas


Lippert 277882 Wear Tab 1.5" OD x 0.58" for 2x2 and 2.5x2.5 Slide-Out Inner Tube Assembly
GE GFQ14ESSNWW Washer Dryer Combo - 2.4 Cu Ft, Ventless, 120V, 24"
Camco 59913 Propane Hose Assembly 3 ft 3/8 in Female Flare x 3/8 in Female Flare
Peterson LED License Light - 4" x 1.63" Oblong, Black
Lippert 277882 Wear Tab 1.5" OD x 0.58" for 2x2 and 2.5x2.5 Slide-Out Inner Tube Assembly
GE GFQ14ESSNWW Washer Dryer Combo - 2.4 Cu Ft, Ventless, 120V, 24"
Camco 59913 Propane Hose Assembly 3 ft 3/8 in Female Flare x 3/8 in Female Flare
Peterson LED License Light - 4" x 1.63" Oblong, Black
$7.64
$1,310.00
$24.49
$16.82