Stop burning through 1 lb disposable Coleman bottles. This certified adapter hose lets you run your portable grill, catalytic heater, or propane lantern directly from a standard 20 or 30 lb refillable propane cylinder -- saving money and keeping your campsite supplied for far longer burn times.
The MB Sturgis 100022-60 (vendor part 06-1377) is a straightforward, well-built solution for campers, RVers, and tailgaters who regularly use portable propane appliances. One end threads onto the handwheel POL fitting of a standard 20 or 30 lb refillable propane tank -- the same tanks used with most RV rigs and backyard grills. The other end terminates in a Male CGA #600 fitting, the same connection found on Coleman-style appliances designed for 1 lb disposable cylinders.
The result is a direct, high-flow connection that replaces the disposable bottle entirely. At 60 inches of working length, there is enough slack to position your cylinder safely away from the flame source while keeping the setup tidy.
Standard left-hand-thread POL fitting with handwheel tightening -- no wrench needed to connect to your 20 or 30 lb propane cylinder.
Matches the inlet port on Coleman-style grills, single-burner stoves, catalytic heaters, and propane lanterns designed for disposable 1 lb bottles.
Flow capacity of 500,000 BTU/hr supports high-demand appliances without pressure drop or performance loss at the burner.
Rated from -40F to 140F (-40C to 60C), making it suitable for cold-weather camping as well as summer heat without hose degradation.
Portable propane appliances -- grills, lanterns, single-burner stoves, infrared heaters -- are built around the CGA #600 connection that threads onto a 1 lb disposable cylinder. Those small bottles run out quickly under heavy use and generate significant waste. This adapter hose converts that same appliance to draw from a standard refillable tank, giving you far more runtime per fill-up with no modification to the appliance itself.
The hose assembly uses 1/4 inch ID thermoplastic construction designed for LP gas service. Thermoplastic LP hose resists abrasion, UV exposure, and the temperature extremes typical of outdoor use better than basic rubber hose. The assembly is certified to CAN/CGA 8.1, the North American standard for LP gas hose assemblies used with low-pressure appliances.
The POL (Prest-O-Lite) fitting on the cylinder end uses a left-hand internal thread, which is the industry standard for LP gas tanks. The handwheel design allows hand-tight connection without tools. Do not use thread tape or sealant on POL fittings -- the seal is made by the fitting geometry, not threads.
The Male CGA #600 outlet connects to the appliance regulator inlet the same way a 1 lb disposable bottle would. Flow is controlled by the appliance's own regulator; this hose does not contain a separate regulator or pressure-reduction stage.