Purpose-built for outdoor environments, the Jensen ASAMS5006WR speakers deliver clear, full-range audio in settings where standard speakers fail. Whether mounted in an RV exterior bay, on a patio wall, under an awning, or on a boat, these speakers are engineered to handle moisture, UV exposure, and salt-air corrosion without sacrificing sound quality.
The ASAMS5006WR features a one-piece molded chassis with an integrated drip-edge that channels water away from the cone and internal components. The polypropylene woofer cone resists UV degradation, while the mylar tweeter delivers crisp high-frequency response even after extended outdoor exposure. The fully sealed design meets ASTM-B117 salt-spray corrosion resistance standards -- the same test protocol used for marine-grade hardware.
This listing includes two speakers. They install into a standard round cutout with a 4-3/8 in. mounting hole diameter, making them straightforward drop-in replacements for many factory-installed RV exterior speakers or common aftermarket speaker locations.
One-piece molded chassis with integrated drip-edge keeps water out of the cone and voice coil during rain, wash-downs, or condensation.
Polypropylene cone and UV-stable white grille resist sun damage and fading. ASTM-B117 compliant for salt-spray corrosion resistance.
Mylar tweeter integrated into the woofer cone covers 79Hz to 20kHz, delivering a wider frequency range than single-cone designs at this size.
4-3/8 in. mounting hole diameter and 1-1/2 in. shallow mounting depth make these a practical fit in thin exterior walls, cabinets, and storage bay panels.
These speakers are a natural fit anywhere standard indoor speakers would be damaged by the elements:
The shallow 1-1/2 in. mounting depth is a significant advantage in RV walls, where cavity depth behind the panel is often limited. Many RV exterior speaker cutouts have less than 2 in. of clearance, and the ASAMS5006WR fits that constraint comfortably.
The 4-3/8 in. mounting hole is a common diameter for 5-inch and 5.25-inch speaker locations. If replacing existing speakers, verify the cutout diameter and mounting depth before ordering. The 5-15/16 in. grille diameter means the grille will overlap approximately 3/4 in. on each side of a 4-3/8 in. hole, which covers minor imperfections in an existing cutout.
These are passive speakers and require connection to a head unit, amplifier, or receiver that provides speaker-level output. They are not self-powered. Standard speaker wire connections apply -- no proprietary connectors.