Keep your Class A motorhome protected during storage with the ADCO Designer Series SFS Aquashed cover. Engineered with 30% more SFS Aquashed material and a triple-layer polypropylene construction, this cover is purpose-built for moderate climates where high humidity and seasonal rainfall are the primary threats to your coach's finish, seals, and exterior surfaces.
The ADCO 52207 uses a triple-layer SFS (Soft-Fab-Soft) Aquashed top panel that beads water on contact, pushing moisture away before it can penetrate or pool. The triple-layer polypropylene side panels allow the cover to breathe, which is critical for preventing trapped condensation from turning into mold and mildew on your sidewalls and slide-outs.
Reinforced front corner stitching resists the snags and tears that commonly occur during installation and removal. A front and rear buckle cinching system removes slack for a fitted, rattle-free profile, while the bottom strap and buckle system locks the cover down in windy conditions.
30% more SFS Aquashed material than previous versions. Beads water on contact and delivers superior resistance to rain and humidity.
Shields exterior gelcoat, decals, rubber seals, and roof membrane from harmful UV degradation during storage.
Triple-layer polypropylene side panels allow moisture vapor to escape, preventing mold, mildew, and trapped condensation under the cover.
Front and rear cinching buckles remove slack. Bottom-mounted straps with buckles prevent wind uplift and keep the cover in place.
This cover is sized for Class A motorhomes measuring 37ft 1in to 40ft in length. The cover dimensions are 40ft long x 106in wide x 132in high -- confirm your coach's actual length, width, and roof height before ordering. Class A coaches vary significantly in slide-out depth and roof profile; use ADCO's sizing guide to verify this is the correct SKU for your specific floorplan.
The weighted buckle toss-under system simplifies installation by one person -- the weighted end is tossed under the coach so you can pull straps through without lying on the ground. Zipper entry panels allow easy cab and door access without removing the entire cover during storage periods.