Replace a worn or cracked propane supply line without the guesswork. The JR Products 06-0150 is a 6-foot OEM-style LP supply hose built for the propane systems found in a wide range of travel trailers, fifth wheels, and motorhomes. With a 1/4" ID rubber hose body and 3/8" female swivel SAE flare fittings on both ends, it connects directly to standard RV LP appliance ports and regulator outlets without adapters. UL and CSA listed for safety and peace of mind.
Propane supply hoses take abuse from vibration, UV exposure, heat cycling, and the occasional accidental kink. When a hose shows signs of cracking, stiffness, or any gas odor near a fitting, replacement is not optional. The JR Products 06-0150 brings the hose back to OEM spec with a rubber inner construction and standard SAE flare thread fittings that mate cleanly with the hardware already in your rig.
At 72 inches (6 feet) of working length, this hose is long enough to route from a regulator or T-fitting to a range, furnace, water heater, or generator connection while leaving enough slack to absorb coach flex and slide movement. The swivel design on both ends means you can tighten the connection without twisting the hose body -- a critical detail that prevents premature cracking at the ferrule.
Six feet of hose provides routing flexibility for appliances mounted behind panels, in basement compartments, or across slide-out sections.
3/8" female swivel SAE flare ends on both sides allow wrench tightening without twisting or stressing the hose body at either connection point.
Tested and certified to UL and CSA standards for use in LP gas systems, meeting the safety requirements expected by RV manufacturers and inspectors.
Matches the thread spec and hose diameter used by many RV OEMs, making this a direct swap in systems already built around 3/8" SAE flare hardware.
Both ends use a 3/8" female swivel SAE 45-degree flare connection -- the same standard used throughout most North American RV LP systems. This fitting mates with 3/8" male SAE flare outlets found on two-stage regulators, LP manifolds, flex connectors, and many appliance inlet fittings. No adapters or thread tape are needed for a standard RV-to-appliance connection.
Rubber LP hoses should be inspected at least once per season and replaced whenever any of the following are present: