Heavy-duty carrier for 3-wheel Auto Moto scooters. 600 lb capacity with reversible rails. Includes 3 ramps, retractable tie-down bars, anti-tilt bracket. Class III/IV hitch. Made in USA.
The VersaHaul VH-AM AutoMoto Carrier is a professional-grade, heavy-duty carrier system engineered specifically for transporting 3-wheel Auto Moto scooters and similar three-wheeled vehicles. This robust carrier can safely handle up to 600 lbs total capacity (500 lbs maximum per rail), making it ideal for large motorized trikes, recumbent trikes, and other substantial three-wheeled transportation. The VH-AM represents VersaHaul's commitment to innovative design, featuring reversible rails that allow loading access from either side of the carrier for maximum flexibility.
Constructed from heavy-duty 14-gauge steel with a long-lasting corrosion-resistant powder coat finish, the VH-AM is built to withstand years of use in all weather conditions. The complete system includes three loading ramps (71" long x 7.625" wide) for easy loading and unloading, four retractable tie-down bars for secure vehicle positioning, and an anti-tilt lock bracket to prevent carrier wobble during transport. At 244 lbs, this is VersaHaul's heaviest carrier and is specifically intended for use on large trucks and motorhome suspensions. The VH-AM is proudly made in the USA and protected by US Patents (US D554,041 S; 20070052206).
Hitch Requirements: • Class III Hitch: Typically rated for 500 lbs tongue weight • Class IV Hitch: Typically rated for 1,000 lbs tongue weight • Receiver Size: Standard 2" receiver Important Hitch Considerations: • Low Hitches: VersaHaul main tube extends from hitch at the same level. Hitches mounted very low to the ground may not work properly - verify ground clearance. • Recessed Hitches: Will shorten the effective length of the carrier tube. Measure your hitch depth before purchasing. Vehicle Requirements: • Large Trucks: Designed for 3/4-ton and 1-ton trucks with robust suspensions • Motorhomes: Suitable for motorhome chassis with appropriate suspension • 1/2-Ton Trucks: May require air helper springs due to carrier + load weight CRITICAL: Always verify your specific vehicle's towing capacity, tongue weight rating, and suspension capabilities before purchasing. The VH-AM weighs 244 lbs empty, so total tongue weight will be 244 lbs + your Auto Moto weight.
This Complete System Includes: • (1) Anti-Tilt Lock Bracket • (1) 44" Main Tube • (1) Extended Wheel Stop (VH-050D) • (2) Standard Wheel Stops (VH-050) • (4) Retractable Tie-Down Bars • (3) Loading Ramps (71" x 7.625") • (2) Reflectors • Installation Instructions Carrier Specifications: • Model: VH-AM • Weight: 244 lbs • Capacity: 600 lbs total (500 lbs per rail) • Rail Length: 71.5" • Rail Width: 6.25" • Ramp Length: 71" • Ramp Width: 7.625"
BEFORE PURCHASING - READ CAREFULLY: Weight Considerations: The VH-AM weighs 244 lbs empty. When loaded with a 600 lb Auto Moto, total tongue weight will be approximately 844 lbs. This substantial weight requires: • A vehicle with sufficient towing capacity and suspension to handle this tongue weight • Potentially upgraded suspension (air helper springs) on 1/2-ton trucks • A properly rated Class III (500 lb) or Class IV (1,000 lb) hitch • Large truck or motorhome - NOT suitable for passenger cars, SUVs, or light-duty trucks Hitch Limitations: • Most Class III hitches are rated for only 500 lbs tongue weight - this limits your Auto Moto to approximately 256 lbs (500 lb hitch rating - 244 lb carrier weight) • Most Class IV hitches are rated for 1,000 lbs tongue weight - adequate for full 600 lb capacity • Low-mounted hitches may cause ground clearance issues • Recessed hitches will reduce effective carrier length Vehicle Suspension: Your vehicle's suspension capacity is the ultimate limiting factor. Check your vehicle's owner's manual for: • Maximum tongue weight rating • Payload capacity • Rear axle weight rating If your vehicle cannot safely handle 844+ lbs of tongue weight, DO NOT use this carrier. Consider upgrading suspension or using a trailer instead. DO NOT use this carrier if: • Your hitch is rated below Class III • Your vehicle's tongue weight rating is less than 850 lbs • You have a passenger car, crossover, or light-duty SUV • Your hitch is mounted very low to the ground (verify ground clearance) • You plan to tow a trailer simultaneously (never use carrier while towing)
Download the VersaHaul VH-AM AutoMoto Carrier Instruction ManualPre-Installation Requirements: 1. Verify your vehicle's towing capacity and tongue weight rating 2. Confirm you have a Class III or IV hitch with 2" receiver 3. Check hitch height and ensure adequate ground clearance 4. Measure hitch depth if recessed to verify carrier clearance 5. Consider upgrading suspension if using 1/2-ton truck 6. Review complete VH-AM instruction booklet before assembly Reversible Rails Feature: The VH-AM's rails can be reversed to allow loading from either the driver or passenger side: • Determine which side provides best access in your garage/driveway • Consider which side has more clearance when parked • Rails can be reconfigured if you change your preferred loading side • Follow manufacturer instructions for reversing rail orientation Driving with Loaded Carrier: • Accelerate gradually - significant tongue weight affects vehicle handling • Brake earlier - stopping distance increases with added weight • Turn carefully - wider turns required due to extended rear length • Watch ground clearance - avoid steep driveways, speed bumps, or rough terrain • Monitor constantly - check mirrors frequently to verify cargo remains secure • Stop after 50 miles - retighten all straps as they may settle • Avoid highways if possible until you're comfortable with vehicle handling characteristics Important Operating Restrictions: • DO NOT ride any vehicle while loading onto carrier - walk it up or use lowest power setting • DO NOT stand on VersaHaul carrier - not designed to support human weight • DO NOT exceed 600 lbs total capacity or 500 lbs per rail • DO NOT use carrier on 5th wheel trailers or any other kind of trailer • DO NOT tow a trailer while using carrier - creates dangerous weight distribution • NEVER exceed your vehicle's tongue weight rating Unloading Procedure: 1. Park on level ground in safe location 2. Reinstall all three ramps onto carrier 3. Remove tie-down straps from all four corners 4. Retract tie-down bars 5. Carefully back Auto Moto down ramps (helper recommended) 6. Remove ramps and store carrier Storage & Maintenance: • Store carrier in dry location when not in use • Periodically inspect powder coat for chips - touch up to prevent rust • Check all bolts and hardware for tightness before each use • Lubricate retractable tie-down bar mechanisms periodically • Inspect ramps for damage, cracks, or bent sections • Clean carrier after each use to remove road grime and salt • Touch up any scratched powder coat immediately to prevent corrosion