A direct OEM-style replacement propane pigtail for RV LP systems. The 06-0127 gives you a reliable 24-inch rubber hose with the right fittings on both ends -- POL on the tank side and a 1/4" male inverted flare on the appliance side -- so you can restore a proper connection without improvising adapters or mismatched hardware.
JR Products designed the 06-0127 as an OEM-grade replacement for the short propane connector hoses used in RV LP distribution systems. These pigtails connect a propane regulator or manifold to a tank valve, and they take daily stress: bending, vibration on the road, and exposure to the elements. The 1/4" ID rubber hose construction handles LP gas service reliably across the range of temperatures typical in RV use.
At 24 inches in length, this hose provides enough reach and flex to route cleanly in most standard RV propane compartments without kinking. Both end fittings are the industry-standard types you will encounter on North American LP systems -- no special tools or thread adapters needed.
POL (left-hand thread) fitting mates directly to standard propane cylinder and tank valves used on most RVs and travel trailers.
The appliance end uses a 1/4" male inverted flare fitting, the standard connection for RV regulators, manifolds, and LP supply lines.
Safety-listed to both Underwriters Laboratories (UL) and Canadian Standards Association (CSA) standards for LP gas hose service.
Engineered to match factory specifications so it installs without modification in standard RV propane compartment layouts.
The 06-0127 pigtail is the short flex hose that runs between an LP tank valve and the inlet of a two-stage or single-stage regulator. It absorbs movement and vibration so rigid copper or steel tubing downstream is not stressed. Common installation points include:
LP hoses should be inspected at least annually and replaced if you notice any of the following: