A direct OEM-replacement propane pigtail hose for RV appliances and portable LP equipment. The 07-30765 bridges a QCC1 tank fitting to a 1/4" male inverted flare connection on your appliance, regulator, or distribution system -- all in a flexible 30-inch rubber hose that meets UL and CSA safety standards.
Propane pigtail hoses take a lot of abuse -- heat cycles, UV exposure, ozone, and vibration from road travel all degrade the rubber over time. Cracks, stiffness, or any smell of gas around the hose are immediate signs to replace it. The JR Products 07-30765 is built to OEM specifications and drops in without adapters when your current hose uses a QCC1 (Type 1) tank connection and a 1/4" male inverted flare appliance port.
At 30 inches, this hose gives you enough reach for typical RV underbelly and exterior compartment routing without excess slack that could kink or chafe against cabinet edges.
Type 1 QCC1 fitting threads directly onto standard 20 lb and 30 lb LP cylinders without tools -- hand-tighten and go.
Standard SAE inverted flare end connects to regulators, manifolds, and appliance inlets designed for 1/4" flare fittings.
1/4" ID rubber hose provides flexibility for routing in tight RV compartments while resisting LP gas permeation.
Meets Underwriters Laboratories and Canadian Standards Association requirements for LP gas hose -- required by most campground and RV park safety codes.
This pigtail is a common OEM replacement across a wide range of RV propane systems:
RVIA and propane industry guidelines generally recommend inspecting LP hoses at least once per year and replacing them every 5 to 10 years regardless of visible condition. Replace immediately if you notice: