Home > Electronics > Seelevel Tank Monitoring System >

Garnet 709-4P SeeLevel (4) RV Tank Monitoring System
Garnet 709-4P SeeLevel II Tank Monitoring System
Garnet SeeLevel II Tank Monitoring System
 
Alternative Views:


Price: $305.95
MFG P/N: 709-4P-1004
MFG: Garnet Instruments
SHIPS: Same Business Day Before 1 PM EST

Quantity in Stock :5

Free Shipping
Availability: In Stock
Qty:

Description Instructions
 
The SeeLevel 4 Tank Monitoring System is designed for accurate level measurement of 5th wheel trailers with four holding tanks. This system monitors battery voltage, fresh, grey, galley and black water levels. The level in percent is shown on a three digit LED display. This model includes a single-pole pump switch on the display panel.
  • Monitors battery voltage, fresh water tank, grey water tank, black water tank and galley tank
    • Includes Fresh Water Pump Switch
  • Provides accurate tank level information using percentage of full readout
  • Tanks are monitored using Garnet’s proprietary external level sensing technology
    • This ends fouling problems caused by debris build-up in the holding tank
    • Detailed diagnostic information monitors sender operation
  • Measures tanks from 3.5" to 34" depending on the sensors you specify.
    • 710-AR Sender (standard) 3.5" min to 10.5" max (stacked = 21")
    • 710-ES2 Sender (optional) 5.5" min to 14" max (stacked = 25")
    • 710-SS Sender (optional) 7" min to 14" max (stacked = 34")
  • Grey and galley water tanks are limited to 14" Tall
    • Sensors cannot be stacked on those tanks
  • Tank senders connect to the display via a common bus network
    • All senders can be connected using the same wire
  • Uses common industry connector for ease of installation and servicing
  • Display requires 12 volts from the RV battery, the system will function from 11 volts to 16 volts
  • Current drain is less than 200mA
  • Panel Dimensions: 4" W x 2.8" H x 1" D
    • Required Cutout Size: 3" W x 1.8" H
  • Includes:
    • (1) Display monitor.
    • (1) pigtail
    • (4) mounting screws.
    • (4) 9″ 710-AR standard tank senders
  • NOTE: If you have taller tank(s) and require a 12" Sender = 710-ES or 16" Sender 710-SS specify in the checkout order notes along with quantity of each.
  • Senders will not work on metal tanks.
  • Limited 1 year manufacturer warranty
  • See our SeeLevel Tank Monitor Comparison Guide to help you choose the right system for your RV.

Garnet 709-4P SeeLevel II Tank Monitoring System

Seelevel 709-4P Tank Monitoring System
Seelevel Sensor Installation
Additional Product Information
Display Mounting Panel: Black flush mount panel, approximately 4” wide by 2.8” high by 1” deep (102mm wide X 71mm high X 25mm deep). Panel screws to wall. Required cutout size is 3” wide by 1.8” high.

System Power Requirements: Display requires 12 volts from the RV battery, the system will function from 11 volts to 16 volts. Current drain is less than 200mA.

Wiring: A single two wire conductor required from the display to the senders. All the senders are wired in parallel. 12 V power and ground required for display. Single wire required for LPG sender if sender grounded at tank.

Pump Switch: The pump and heater switch is rated for a maximum of 6 amps. A relay is required if more than 6 amps is needed. A 7.5 amp fuse is included.

ACCESSORIES
Garnet 709-gasket SeeLevel 709 Gasket Garnet 710-SS SeeLevel Sender Board - 16" Garnet 709-filler SeeLevel 709 Filler Plate Garnet 709-4P SeeLevel II 4 Monitor - Monitor Only
Price: $10.25
Price: $59.95
Price: $10.25
Price: $84.95
Garnet 709-gasket SeeLevel 709 Gasket Garnet 710SS SeeLevel II Sensor Board - 16" Garnet 709-filler SeeLevel 709 Filler Plate Garnet 709-4P SeeLevel II Monitor - Monitor Only