The On The Go OTG2-SDI Portable Mixed Bed Water Deionizer produces mineral-free water that leaves no water spotting after rinsing a clean RV. Provides approx. 225 gallons of deionized water before recharging. Good for approx. 7 Class A RV rinses before recharging.
- Class A RV Rinses: approx. 7 rinses before recharging.
- Car Rinses: approx. 45 rinses before recharging.
- Gallons: approx. 225 gallons before recharging.
- Features high grade virgin mixed bed resin
- Resin refills available separately, see part OTG-SDI-1
- TDS meter lets you know when to recharge the deionizer.
- Easy and fast hook-up.
- Standard hose connections.
- No tools required.
- No need to dry after washing.
- Flow Rate: Less than 2 gallons/minute for best performance & effectiveness
- Includes a 1/4" cubic feet of high grade virgin mixed bed resin, a high-flow shut-off valve, 4 ft hose, cap and plug for travel plus an easy-to-read handheld TDS meter.
- Compact and lightweight, only 18 lbs.
- Dimensions: 22" height x 6-3/4" diameter.
- Tank Size: 0.25 cubic ft.
- Weight: 18 lbs.
- Limited 1-Year Manufacturer Warranty.
- Made in the USA.
On The Go Portable Mixed Bed Water Deionizer
Installation Instructions:
1. Install Hi-Flow shut-off valve to inlet side of tank (optional/if provided). 2. Connect water source to the inlet of the deionizer (if you have the Dual/Tri Bed DIs, connect the units together with the cam level coupler). 3. Make sure deionizer is standing upright for use. 4. Flush out system for 2-3 minutes (gets out all the resin dust). 5. Connect outlet to point of use. 6. Your new unit is ready for use!
Recharging Directions:
Step 1: When output water quality has exceeded pre-determined level, or when spotting occurs, DI water is no longer being produced. Shut off water supply and remove tank head. Step 2: Empty resin into a waste container and rinse out tank. Dispose in accordance with federal, state, and local regulations. Step 3: Return distributor tube into the tank and place rubber cap over top of tube. Place funnel into top of the tank. Step 4: Slowly pour or scoop resin into tank. Shake or tap tank to get all of the resin bedded. Lastly, finish filling the unit with resin to within 2 inches of the top. Step 5: Remove funnel and rubber cap. Replace tank head. Make sure all o-rings are properly seated. Ensure seating areas are free from foreign material. Apply silicone lubricant to surface of o-rings. Step 6: Connect the water source to the inlet of the deionizer. Turn on the water and flush out the system for 2-3 minutes (gets out all of the resin dust). The unit will now produce deionized water.
|