OEM direct replacement coil for the DV1 directional valve on EQ Systems MTE hydraulic pump assemblies. Restores proper electrical actuation of the DV1 valve when the original coil is corroded, shorted, or open.
The EQ Systems 1746 is the OEM replacement electromagnetic coil for the DV1 directional valve on EQ Systems MTE hydraulic pump manifolds. The coil is the electrical component that actuates the DV1 valve — when the control panel sends a signal, current energizes the coil, which magnetically opens or shifts the valve to direct hydraulic flow for jack extension or retraction.
The coil is a separate serviceable component from the valve body itself. When a coil fails due to corrosion, moisture, overheating, or electrical fault, it can be replaced independently without replacing the entire DV1 valve assembly.
The DV1 assembly consists of two separate serviceable parts: • #1746 (this part) — The electromagnetic coil that electrically actuates the valve • #1717 — The valve body (mechanical/hydraulic component) EQ Systems recommends testing the coil with an ohm meter before replacing it. On the 2-terminal DV1 coil, there should be continuity across the two terminals, and no continuity between either terminal and ground (with wires disconnected). Common symptoms of a failed DV1 coil: • Jacks will not extend when commanded • No response from DV1 despite correct voltage at the green wire • Coil is visibly corroded or shows signs of heat damage
The 1746 is the replacement coil for the DV1 valve on EQ Systems MTE pump assemblies. Coil specifications vary between pump types and valve designations — confirm you have an MTE pump and that DV1 is the valve needing repair before ordering. The model number tag is located on the pump motor or manifold. Contact EQ Systems technical support if you are unsure which coil your system requires.
Have your pump model number ready when contacting EQ Systems support. The model number tag is located on the pump motor or manifold. Technical Support: EQ Systems Toll Free: 1-800-846-9659 Local: 574-264-3437 Hours: Monday–Friday, 7AM–4PM EST Manufacturer: EQ Systems — 19300 Grange St, Cassopolis, MI 49031