Blue Streak Thetford Aria (2003 and Newer) Single Vacuum Breaker Model Installation



INSTALLATION INSTRUCTIONS
Thetford Aria (2003 and Newer)
Single Vacuum Breaker Model

 
1. Remove the stool.

A. Remove two bolts, one on each side.
B. Remove the water line located at the rear of stool.
(MAKE SURE WATER IS OFF).
C. Unhook wires to stool.

 
2. Locate flush line between vacuum breaker and bowl.

A. Cut the flush line half way between vacuum breaker and bowl. [Photo View 1]
B. Insert T-valve with small arrow pointing toward the bowl. [Photo View 2]
THIS IS VERY IMPORTANT
 
(T-valve will not work if installed backwards)
C. With the two hose clamps enclosed in kit secure T-valve in place. [Photo View 3]

Cut tubbing on Thetford Aria (2003 and newer) single vacuum breaker model
[View 1]

T-Valve installed on Thetford Aria (2003 and newer) single vacuum breaker model.
[View 2]

T-valve secured in place on Thetford Aria
[View 3]

 
3. Reinstall stool making sure all gaskets, bolts and water connections are secure. Reattach the wires.
 
4. Mounting the dispenser reservoir to the wall.

A. Locate reservoir to the back or side of the wall providing easy access for filling.
B. Keep level or lower than back of stool.
C. Screw reservoir into place with the three screws provided.

 
5. FINAL CHECK LIST

A. Check water line for leaks.
B. Check stool by flushing.
C. Add a few ounces of Blue Streak Chemical to reservoir.
D. Flush stool. Finish filling reservoir.

 
6.     Q: How do I winterize the Blue Streak Dispenser?

A: Run the chemical level low [1to 2 inches] in the reservoir and winterize your unit as you would normally. To remove chemical from the reservoir; unscrew the tank from the wall leaving tubing attached to tank and pour chemical into another container.