• Controls flow rate during regeneration.
• Y shaped assembly valve.
• Durable plastic material.
• Made in The USA

• Close the inlet and outlet valves and connect a garden hose to the drain port of the Y valve. Open the drain valve to relieve any pressure in the system.
• Once the pressure is relieved close the drain valve port and remove the system from the RV.
• Gently tilt the system to drain some water out of the mineral tank to create room for salt.
• Once a few cups of water have been drained from the system, remove the tank head fill port, and pour 2 lbs of sodium chloride table salt into the fill port on the head. Use a cup of water to rinse the fill hole clean of salt crystals and reinsert the fill plug.
• Allow the unit to set for 5 minutes, then turn on the inlet valve and open the drain port on the Y valve to begin the brine rinse process.
• After 20 minutes of brine rinsing the system is ready to be installed back into the RV and is ready for use.
• Regeneration should be performed when the hardness from your system exceeds 3 grains per gallon as indicated on the supplied water test strips.

Flow-Pur Y-Valve For RVPro